Ice Maker Repair in Lebanon, TN
No ice, small cubes, or water leaking onto the floor — we diagnose the real cause and quote the full repair before we touch anything. Residential repairs run $100–$600. We apply the 50% rule: if replacement makes more sense, we'll tell you.
Lebanon's Water and Heat Are Hard on Ice Makers
Local conditions matter more than most people realize.
Lebanon sits over limestone karst geology. Your tap water carries dissolved minerals that accumulate inside inlet valves, water lines, and ice molds — faster than you'd see in softer-water cities. Summer highs near 90°F force the compressor to work harder, and that means marginal components fail sooner.
Neighborhoods like Five Oaks, Hamilton Springs, StoneBridge, and Horn Springs are served by the same regional water supply. If your ice maker is producing small, cloudy, or hollow cubes — or has stopped entirely — mineral scale or heat stress is often the starting point for diagnosis.
We service all neighborhoods across Lebanon and Cairo Bend. No upselling a water softener you don't need — just an honest diagnosis and a quoted repair.
What We Diagnose and Repair
Every failure mode, diagnosed at the source.
No Ice Production
Failed water inlet valve, frozen fill tube, or a dead ice maker module. We find which one before quoting.
Small or Hollow Cubes
Low water pressure or a partially clogged valve restricts fill volume. Often a straightforward valve swap.
Ice Maker Leaking Water
Cracked fill cup, loose water line connection, or a defrost drain issue. We trace the leak to the origin.
Ice Tastes or Smells Off
Old filter, mold growth in the bin, or a contaminated water line. Cleaning and part replacement as needed.
Ice Maker Won't Stop Running
A stuck shut-off arm or failed control module. Left unattended, this overflows the bin and floods the floor.
Built-In and Undercounter Units
We repair freestanding and built-in ice makers across all major brands — not just refrigerator-integrated units.
Repair Pricing in Lebanon
You see the full number — parts and labor — before we start.
Residential
Inlet valve replacements and frozen fill tube clears sit at the lower end. Ice maker module replacement or sealed-system work trends higher. Diagnostic fee disclosed upfront and applied toward the repair if you proceed.
Residential ice maker repair →Commercial
Commercial ice machines involve more complex water distribution systems and higher-capacity components. We quote before we work — no surprises on the invoice.
Commercial ice maker repair →The 50% Rule
If the repair quote exceeds half the cost of a comparable new unit and the appliance is past its midlife, we tell you to replace it — honestly, even though it costs us the job.
Get an honest quoteWhy You Can Trust the Quote
Ice Maker Repair FAQ
Why did my ice maker suddenly stop?
The most common causes are a failed water inlet valve, a frozen fill tube, or a worn ice maker module. We diagnose the root cause — not just the symptom — before quoting any repair.
Does Lebanon's water quality cause problems?
Yes. The limestone karst geology under Lebanon means moderately hard water. Mineral scale builds up in inlet valves and ice molds over time, accelerating failures compared to softer-water areas.
How long does the repair take?
Most repairs are done in one visit when the part is stocked. Inlet valves and modules for major brands are often on the truck. Control boards and parts for older or niche models can take 2–7 days.
Do I need a permit for ice maker repair?
No. Appliance repair in Lebanon and Wilson County requires no permits — it's service work, not construction. If we uncover a plumbing or electrical issue behind the wall, we'll say so and refer you to the right trade.
When should I replace instead of repair?
We apply the 50% rule: if the repair quote exceeds half the cost of a comparable new unit and the appliance is past its midlife, we'll tell you to replace it. That honesty costs us the job — we do it anyway.
What if the ice maker is leaking into my floor?
Shut off the water supply line to the unit immediately — the valve is usually behind the fridge or under the sink. Then call us. A leaking ice maker can damage flooring fast; don't wait on this one.
How a Repair Visit Works
-
1You describe the symptom — we schedule the visit.
Tell us what the unit is doing (or not doing). We'll give you an appointment window and confirm the diagnostic fee before we arrive.
Day 1 -
2On-site diagnosis — root cause only.
We test water pressure, inspect the inlet valve, check the fill tube, and run the ice maker module. No guessing, no parts-shotgunning.
Same visit -
3Full quote — parts and labor — before we touch a screwdriver.
You approve the number or you don't. We apply the 50% rule here. If we recommend replacement, we explain exactly why.
Same visit -
4Repair completed or part ordered.
Common parts are on the truck. If we need to order, we give you a realistic lead time — not a vague "a few days."
Same visit or 2–7 days -
5We verify the fix before we leave.
We run a full cycle and confirm the unit is producing ice correctly. If something looks off, we address it on the spot.
End of repair visit
Other Appliance Repairs in Lebanon
Your ice maker isn't going to fix itself.
We're available in Lebanon and across Wilson County. Get a full quote — no obligation, no pressure — and we'll tell you straight whether the repair is worth it.
Request a Repair Quote